Set up and use

Business WLAN-Box

Get to know the device

  1. Pair button
  2. WLAN button (inactive)
  3. Power button
  4. Power
  5. Reset button
    After 7 seconds, all LEDs flash red and then white (1 - 2 x per second)  device restarts
  6. 2 LAN Ethernet connections

Power LED

Steady white The device is ready for operation.
Flashing white The device is starting, being configured or updating.
Please do not switch off.
Steady red There is a fault. Restart the device.

Status LED

Steady white WLAN is an ideal distance from the router.
Flashing white WLAN is too close to the router or the nearest WLAN-Box.
Steady red WLAN is too far away from the router or the nearest WLAN-Box.
LED not on WLAN is switched off or not paired to the router. 

Pairing LED

Steady white Pairing between the router and WLAN is OK. 
Flashing white
(1–2x per sec.)
Pairing is complete.
Steady red Pairing with the router cannot be restored.

FAQs

Type 192.168.1.1(opens in new tab) into your Internet browser. Please note that you will only be able to access this address if you are in the same network as the Centro Business 3.0 router. Log in with your existing admin password for your Centro Business 3.0 router. If you do not know the password, visit the Router Administration section of your My Swisscom Business(opens in new tab) (Customer Center).

You can only use the Business WLAN-Box in combination with the Centro Business 3.0.

Find out the energy consumption of your Business WLAN-Box here:

Energy consumption

The firmware on your Business WLAN-Box will be updated automatically as soon as a new version is available.

Firmware

No suitable answer found?

Help from the Swisscom Community

Know more together: Our community with over 10,000 active users will be happy to support you.